Analysis of the Effects of Partially Hydrolyzed Polyamide on Oil Reservoir Rocks

The exploitation of heavy oil fields has recently gained momentum due to increased investment in new oil and gas fields and especially due to environmental legislative constraints. That is why in this article I have described the possibility of using partially hydrolyzed polyacrylamide in the exploitation of heavy crude oil deposits, by injecting it into reservoir rocks followed by injection of reservoir water. The role of this polymer is to provide lubrication of the crude oil and water flow channels and especially to block (by reverse osmosis) the large pore communication channels in order to limit pressure leaks in uncontrollable areas. In the study we created two polymers that were used in order to increase the flow rate and decrease the viscosity and the freezing point (additives that are easy to procure and especially with spectacular results in the treatment of stills and without affecting the stability and quality of the final products refinery). We also studied the flow of the polymer through carbonate reservoir rocks, managing to obtain a numerical model that provides data on the rock resistance factor to the flow of partially fluidized polyacrylamide. The adsorption on the surface of the rocks determined the reduction of the mobility of the polymer but also the modification of the gel structure by the modification (crossing) of the polymer (of the polymer chains) which led to clogging (blocking of the pores) and increasing the possibility of fluid flow. In the laboratory we determined the adsorption of silicon for a solution of polyacrylamide of 0.05% partially hydrolyzed concentration in water, it increases from the value of 0.01 mg/m2 to 0.05 mg/m2 when the concentration in NaCl increases from 0 .5% to 10% in are we showed that adsorption increases for pH values ​​lower than 7, and it is stated that for a porous sand medium with a permeability of 140 mD, replacing saline water with 20 g/l NaCl, a presence of the polymer with a concentration of 400 ppm was observed in the effluent, and this value being approximately stabilized after 5 injected pore volumes.